Egw SIG SAUER P220-229, 320 TRIJICON RMR SIGHT MOUNT 49518

THIS MOUNT DOES NOT WORK WITH ANY SIG OPTICS READY PISTOLS (P320 X-CARRY ETC.)

• Material: 7075 Aluminum
• Coating: Matte Black Hardcoat
• Overall Length: 1.780"
• Overall Width: 1.1"
• Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
• Red Dot Fitment: Trijicon RMR, Holosun HS507C

This mount fits (including but not limited to):

• Sig #8 Sights
• P220
• P224
• P225
• P225-A1
• P226
• P227
• P228
• P229
• P238
• P239
• P245
• P320
• P938
• SP2022
• M11-A1
• MK25
• Bersa Thunder UC Series (9/40/45)
• Bersa Thunder HC Series (9/40/45)
• FN 509

This mount does not fit:

• Sig 1911s
• Any Optics Ready Sigs i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.
• P210 Target
• P365 (The dovetail cut is too deep to work with our mount)
• FN 509 Tactical

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions

• Remove the rear sight*
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.