Egw WALTHER PPQ M2 LEUPOLD DELTAPOINT PRO SIGHT MOUNT 49394

• Material: 7075 Aluminum
• Coating: Matte Black Hardcoat
• Overall Length: 1.811"
• Overall Width: .99"

Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw

Red Dot Fitment: Bushnell RXS-100 Crimson Trace CTS-1500 Holosun 407K* Holosun 507K* Holosun EPS-GR* Holosun EPS-RD* Holosun EPS-Carry-GR* Holosun EPS-Carry-RD* Jpoint Leupold Delta Point Pro Optima Redfield Accelerator Shield RMS Shield RMSc Shield SMS Sig Romeo Zero

EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions

• Remove the rear sight*
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.