Manticore Arms Scorpion EVO Bench Block MA-20800

Instead of just clamping your Scorpion EVO in a vise to get the barrel nut off and do maintenance and risk damage to the polymer receiver you can now use our Scorpion EVO Bench Block to do the job! The Bench Block is made of a heavy duty blue polymer that will not mar the surface of the receiver, and is shaped to fully support and distribute loads on the reciever while working on the gun.  Four inlcuded bolts with nuts and washers are used to "clamshell" the receiver with the two blocks, and then the blocks, instead of the reciever, can be clamped into a vise to do work on the gun. Please note that the OEM barrel nut is typically installed with thread locker, and that heat should be applied with a heat gun or carefully with a propane torch to break down the thread locker prior to trying to remove the barrel nut, even when using the Bench Block.   We have seen some nuts come off with almost no force, and some require very high amounts of force to break them loose. If in doubt, take the gun to a Gunsmith to have the work done.  Due to the inconsistent amount of thread locker used by CZ on the barrel nut Manticore Arms cannot be held liable for damage to the gun or components of the gun even when using the Bench Block. The Bench Block is made of sturdy polymer right here in the USA, has the instructions molded onto it, and comes with four bolts with nuts and washers to assemble the block around the reciever. Manufacturer Part Number: MA-20800 Manufacturer Part Number: MA-20800